Which battery incentive does your site fall under?

From 1 September 2026, NSW runs three commercial battery incentives. They are separate activities, with separate eligibility, separate capacity bands and separate conditions. The one that applies to your site is decided by what the building is and how much storage you are installing, not by what industry you are in.

That distinction does a lot of work, and it is why most people who go looking for a straight answer come back an hour later without one.

Three questions decide it. What is the building: an apartment block, a business premises, or a commercial or industrial site. How much usable capacity is the battery, usable rather than nameplate. And is there solar on site, or in the same scope of works. For two of the three activities that last one is not optional.

This page is the map. It tells you which activity your address sits in and why. Each activity then has its own page carrying the detail, the conditions and the primary sources, and those are linked as you go. Nothing here is repeated there, and nothing there is summarised here.

The incentives sit under the NSW Peak Demand Reduction Scheme¹, and it is worth being clear about what that scheme is, because it explains every eligibility rule that follows.

The PDRS is not a solar scheme and it is not a decarbonisation scheme. It exists to reduce demand on the electricity network at the times the network is under most strain, and it pays for the capability to shift load away from those peaks. A battery is one way to deliver that capability, which is why the scheme cares how much storage a site can dispatch and when, and why it does not especially care what the business does.

That is also why eligibility keys off building classification rather than industry. An apartment block and a light manufacturing shed present very different load shapes to the network, so they sit under different activities with different rules. A bakery and a panel beater, both operating from similar premises with similar loads, sit under the same one.

NSW confirmed the three activities on 18 August 2026. They commence on 1 September 2026.

The activity written for apartment buildings covers Class 2 buildings under the National Construction Code with four or more dwellings². This is the activity most likely to be missed, because almost nothing in solar or battery marketing is written for strata.

The business activity covers commercial premises, and explicitly excludes residential buildings and data centres³. If your site is mixed use, retail at ground level with apartments above, the classification of the part of the building the system serves is what matters. Get that determination in writing before anyone prices anything.

The commercial and industrial activity is the largest, and runs to a substantial upper limit⁴.

The boundaries bite in predictable places: mixed use buildings, sites with more than one NMI, and buildings where the metering arrangement does not match the ownership arrangement. If any of those describe your site, the building question is not a formality and it should be settled first.

The classification belongs to the building, not to the business inside it. A ground-floor consulting room in a residential flat building is in an apartment building. A house-shaped terrace occupied entirely by an office is a commercial premises. Where a site genuinely straddles the two, the occupancy classification on the building's own certificate settles it, not the tenancy schedule.

Usable capacity and nameplate capacity are different numbers, they can differ by a material margin, and the difference is the manufacturer's depth of discharge limit. A datasheet headline is not the number the scheme is interested in.

This is the figure that catches quotes out more than any other, because both numbers are true and only one of them is the test. Nameplate is what the cells hold. Usable is what the system will actually discharge after the reserve the manufacturer keeps back. A system quoted at nameplate can sit inside a band on paper and outside it in fact.

Each activity has a capacity band⁵. The commercial and industrial activity has also been reported as carrying a maximum battery duration⁵, which constrains the ratio of energy to power rather than total size. A large battery with a small inverter can fail it while a smaller, better matched system passes.

Two practical consequences. If your site sits near a band boundary, the system design decides which activity you fall under, which means it decides the conditions attached. And a system designed to a round number for procurement reasons may sit just the wrong side of a threshold for no engineering reason at all.

This is the condition that will catch the most proposals out.

The apartment activity does not require solar. A building can install storage on its own and qualify.

The two business activities do require solar, either existing or installed in the same scope of works, at a fixed ratio to battery capacity⁵.

Read that again if you are holding a battery only proposal for a commercial site. It does not qualify. Not qualifies for a reduced amount. Does not qualify.

There is a second order version of the same problem that is easier to miss. If the array was sized for the building's load, as arrays normally are, it may still fall short of the ratio the battery requires. The fix is a resize, and a resize changes the cost, the roof plan, the inverter selection and sometimes the switchboard. None of that is fatal. All of it is far less expensive to discover before a proposal goes to a board than after.

There is a version of this that catches homes and buildings which already generate. An array is normally sized against what the building uses, which is the right way to size an array and has nothing to do with the ratio a battery requires. So a site can have perfectly good existing solar, add a battery, and still fall short of the threshold.

The same three tests, applied to each activity in turn. Every band and ratio below is a reported figure rather than a verified one, which is the reason for the numbers beside them.

There is no fixed incentive amount, and any quote that states one without an assumption behind it should be treated with care.

The value arrives through Peak Reduction Certificates. The project creates certificates, the certificates sell into a market, and that market carries a price that moves. New South Wales publishes a Certificate Estimator⁶ for a specific address, and that is the right starting point.

One event makes the point better than any explanation. In November 2025 the 2026/27 target under the Peak Demand Reduction Scheme was cut to 0.5 per cent, down from 7.5 per cent⁷. No eligibility rule was amended. The target moved, the certificate market responded, and the value of every project changed anyway.

Why nobody can quote an exact figure, and the five things a quote needs before you can rely on it, are set out in full on the technical page for that question. Read it next if you are holding a quote today.

The federal Cheaper Home Batteries Program covers households, small businesses and community organisations, and delivers its support as an upfront reduction through small-scale technology certificates. The apartment activity has been reported as stackable with it up to a capacity limit⁸.

Two conditions on the federal side surprise people. The battery must be paired with solar, new or existing. And a grid connected battery must be capable of joining a virtual power plant, though actually joining one remains a choice.

If you are holding a proposal, the useful next step is to have it read against the rule rather than against the brochure. Which activity it falls under, whether the capacity sits inside that activity's band, whether the array is sized to satisfy the ratio where one applies, and what would have to change if it is not.

That takes about an hour and it does not require you to change supplier. If the proposal stands up, you will know. If it does not, you will know before it goes to a board rather than after the array is on the roof.

New Ability Energy came to renewables from electrical contracting rather than the other way around, which is why questions about switchboards, metering and commissioning tend not to come as a surprise at the end of our jobs. We hold the design, the electrical work, the commissioning, the documentation and the warranty under one contract. Send us the proposal you have and we will tell you where it stands.

We run these three questions against your address before a design is drawn, because the answer changes what is worth designing. You get told which activity applies and what the test was, and if a site does not qualify we say so at that point rather than at quoting.